Doodlemoth

← All patterns

Tidemark

IntermediateCurvesEdge-huggingStrokes: line, curve
Example of Tidemark
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw the tidemark first: one line along the middle of the section, halfway between its edges, where rows from different sides will meet. From each corner, run a line in to meet it, and carry any end that stops short straight on out to the edge.
  2. Step 2: the new strokes are redAlong the edge of the section, draw a row of arches with their feet touching, then draw the next row on top so each new arch spans from the top of one arch below to the top of the next. Each row runs right up to the tidemark and puts a foot on it, so rows from both sides share their feet there; an arch that runs into the line stops at it.
  3. Step 3: the new strokes are redInside every arch, draw one aura a pen-tip in from it, and keep adding rows inward while there is room for a whole row before the tidemark.
  4. Step 4: the new strokes are redClose up to the tidemark: where the last gap is less than a full row, draw taller or shorter arches whose tops just touch the line, and where two lines meet in a point, finish it with one low arch with a foot on each line. Give each of these its aura too.
  5. Optional: fill inFill the inside of each aura solid black.

Next to another sectionWherever a line from the neighbouring section reaches the string line, let it end on the edge at the point where two arches meet.

Fitting it to the spaceLet the pattern take its cue from the nearest edge. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.