Doodlemoth

← All patterns

Fanweave

IntermediateCurvesEdge-huggingStrokes: line, curve
Example of Fanweave
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw a short straight spine along the edge of the section. From its left end draw an arch that rises to a point above the middle of the spine; from its right end draw a second arch that rises to meet it, like half a shell.
  2. Step 2: the new strokes are redStep a little way in from the left end and draw an arch that crosses just past the middle and stops where it meets the right-hand arch. Step in from the right end and do the same back the other way, stopping on the arch you just drew. Keep taking turns, stepping in a little each time, until you reach the middle of the spine: the stopping points make a zigzag seam down the fan.
  3. Step 3: the new strokes are redFit more fans into the space that is left, big and small, each with its spine on the section edge or against the curve of a fan already drawn. Where a new fan runs into an earlier one, stop its strokes at that fan's edge, so it tucks in behind.
  4. Step 4: the new strokes are redOptional: fill inFill the gaps between the fans solid black.

Fitting it to the spaceLet the pattern take its cue from the nearest edge. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.