Doodlemoth

← All patterns

Starweave

AdvancedLinesOrbsStrokes: line, orb
Example of Starweave
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw one large five-pointed star without lifting your path, as a ribbon of two parallel lines. At each crossing the ribbon goes over, then under, then over: draw the leg on top straight through, and stop both lines of the leg underneath at the edges of the one on top. On a big star, make the ribbon wide enough to hold two or three strips.
  2. Step 2: the new strokes are redSplit the ribbon into strips: on a big star, draw one or two auras just inside each edge, a hair apart, so it reads as flat strips laid side by side. Then run a centre line down the middle of every strip. Where the ribbon passes under, stop each new line at the edges of the ribbon on top.
  3. Step 3: the new strokes are redFill the leftover space with smaller stars drawn the same way, each one a single ribbon or, if tiny, a single line, and tuck small orbs into the gaps that remain.
  4. Step 4: the new strokes are redOptional: fill inFill the small pentagon in the middle of every star solid black.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.