Buttonweave
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Pencil a loose grid of dots, letting the rows run alongside the nearest string line. Along each row, draw a band of two gently curved lines that starts a little short of one dot, runs right across the next dot and stops a little short of the dot after. Start the next band just past that same dot, and shift the bands by one dot on every row.
Down the columns, draw bands the same way: each one runs across a dot where the row bands stop, and stops a little short of the dots the row bands run across.
Draw an orb round every dot in two pieces, one small arc on each side of the band that runs across it: leave one band line, curve round past the ends of the bands that stop there, and come back to the same band line.
- Optional: fill inFill the little caps of every orb, where they peek out beside the bands, solid black.
Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.