Doodlemoth

← All patterns

Scalegrid

IntermediateGridCurvesOrbsStrokes: line, curve, orb
Example of Scalegrid
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw slanting lines across the section about a finger-width apart, then cross them with a second set slanting the other way, so you get a grid of diamonds. Let every short stretch of line between two crossings sag a little toward the same side, so each diamond comes out pointed at the top and rounded at the bottom, like a scale.
  2. Step 2: the new strokes are redIn the top point of every scale, draw a small orb tucked into the corner.
  3. Step 3: the new strokes are redInside each scale, draw two curved rib lines that follow its rounded lower edge, one inside the other, running from one side of the scale to the other below the orb. In most scales add a third, shorter rib inside those two.
  4. Optional: fill inFill the strip between the rounded lower edge and the outer rib solid black in every scale, and fill each orb black too.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.