Doodlemoth

← All patterns

Orbwrap

IntermediateOrbsCurvesGridStrokes: orb, curve
Example of Orbwrap
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redScatter small orbs over the section in loose, staggered rows, each row shifted half a space from the one before. Let the rows drift and the spacing vary, so nothing lines up neatly.
  2. Step 2: the new strokes are redBetween each pair of rows draw a wavy line that hugs the underside of an orb in the row above, bows out as it crosses the gap, hugs the top of the next orb in the row below, and so on all the way along.
  3. Step 3: the new strokes are redDo the same between each pair of columns, hugging the sides of the orbs. Where a new line joins the same two orbs as a line already there, bow it the other way, so the two cross and open into a little eye. Every orb ends up held by four curves.
  4. Optional: fill inFill every orb solid black.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.