Twinerail
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Across the section, following the nearest edge, draw a narrow set of three straight lines close together. Leave a channel about a finger wide and draw another set of three beside it. Leave an open gap and do the same again, until the section is full of these rails.
In every channel draw a chain of leaning S-curves: each one hooks up to touch the top rail, slants down across the channel and hooks down to touch the bottom rail, its tip curling back up. Start each new S on the body of the one before, and let its body pass right through the tip of that S's lower hook, so the S-curves touch at both ends like the twists of a rope.
Put a small dot in each pocket between two neighbouring S-curves.
- Optional: fill inFill the open gaps between the strands solid black.
Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.