Trioband
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Draw lines across the section that follow the nearest edge, roughly a finger's width apart and a little uneven, so the section is cut into ribbons. Let every line run right to the edge of the section.
In the first ribbon draw three orbs side by side, each nearly as tall as the ribbon and almost touching the next, then leave a gap about as long as one orb and draw three more, and so on along the whole ribbon. In the next ribbon start half a set further along, so its orbs sit beside the gaps of the ribbon before. Where a set reaches the edge of the section, draw as many of its orbs as fit and stop.
In every gap, draw three short lines straight across the ribbon, close together and evenly spaced, from one ribbon line to the other.
Fitting it to the spaceLet the pattern take its cue from the nearest edge. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.