Doodlemoth

← All patterns

Slatwave

IntermediateCurvesLinesEdge-huggingStrokes: curve
Example of Slatwave
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redJust inside the edge, imagine a strip that follows the edge. Draw a curved arc that starts on its outer side and swings across to the inner side, bulging forward, then a second arc between the same two ends that bulges less, so you get a slim crescent. Draw the next crescent a little further along, starting its arcs only where they come out from behind the one before, so each tucks behind its neighbour. Keep going all the way round the strip.
  2. Step 2: the new strokes are redRun a rib line down the middle of every crescent, following its curve, so each one looks like a twisted strand.
  3. Step 3: the new strokes are redLeave a narrow gap and start the next strip just inside, with its own crescents and rib lines, until the section is full.
  4. Step 4: the new strokes are redOptional: fill inFill the little gaps between the crescents, along both sides of the strip, solid black.

Fitting it to the spaceLet the pattern take its cue from the nearest edge. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.