Shingle
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Along one side of the section, draw a row of rounded wedges side by side, like petals or roof shingles: each one's wide base sits on the edge and its rounded point leans a little as it heads into the section.
Draw the next row behind the first: set each wedge in the dip between two wedges in front, start its outline where it meets the row in front and stop where it meets it again, so only its upper part shows. Keep adding rows the same way until they run off the far edge.
On every wedge, thicken the right-hand side edge into a black sliver that tapers at both ends, and add one short crease line beside the point.
- Optional: fill inFill the lowest showing part of every wedge behind the first row solid black, so each row throws a dark shadow onto the row behind it.
Fitting it to the spaceLet the pattern take its cue from the nearest edge. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.