Doodlemoth

← All patterns

Scrolleaf

AdvancedCurvesGrowingStrokes: line, curve
Example of Scrolleaf
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw one big leaf stem: start at the edge of the section with two lines close together, swing them through a long, gentle S-curve, and roll the end up into a scroll, letting the two lines meet in a point at its centre.
  2. Step 2: the new strokes are redOn the outside of the stem (the side the scroll does not roll toward), draw a row of rounded lobes from the edge to where the scroll begins, each leaning toward the scroll and a little smaller than the one before. Draw the first from the stem out and back to the stem. Start each next one on the stem a little further along, swing it out and back, and stop where it meets the lobe before.
  3. Step 3: the new strokes are redDraw one curved vein in each lobe, from the stem toward its tip.
  4. Step 4: the new strokes are redFill the spaces with smaller leaves made the same way: a stem rolled into a scroll, a row of lobes, one vein in each lobe. Start each from the edge or from behind a leaf already drawn, and stop every line where it meets one already there. Keep going until the section is full.
  5. Step 5: the new strokes are redOptional: fill inFill the paper left between the leaves solid black, right into the curls of the scrolls, so the leaves stand out like carving.

Next to another sectionWherever a line from the neighbouring section reaches the string line, carry it on as one line of a leaf stem that sweeps in and rolls up into a scroll.

Fitting it to the spaceLet the pattern take its cue from the nearest edge. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.