Doodlemoth

← All patterns

Sashcross

IntermediateLinesGridStrokes: line
Example of Sashcross
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw wide sashes straight across the section on a slant, side by side with a gap about half again as wide as a sash between them. Each sash is two parallel lines with a narrow edging line just inside each edge.
  2. Step 2: the new strokes are redDraw a second set of sashes crossing the first at a right angle. These pass underneath: stop every line where it meets the edge of a sash already drawn and pick it up again on the far side.
  3. Step 3: the new strokes are redTrim every sash along its length, switching between close diagonal stripes and a row of small diamonds. On the top sashes, mark each switch with a short line across, halfway between crossings; on the lower sashes, each piece between two top sashes gets one trim.
  4. Optional: fill inFill the open gaps between the sashes solid black, so the sashes lie on a dark ground.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.