Doodlemoth

← All patterns

Riverband

IntermediateLinesCurvesOrbsStrokes: line, curve, orb
Example of Riverband
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw a gently wavy line across the section from edge to edge. Just above it draw a second line that follows the same waves, but every so often let it swell up into a smooth bump, leaving a little pocket between the two lines.
  2. Step 2: the new strokes are redPut a small orb in each pocket. Make the odd pocket long and low and line it with a row of three or four tiny pebbles instead.
  3. Step 3: the new strokes are redKeep adding lines above and below, each following its neighbour closely and rising smoothly over every bump, with a new pocket and orb here and there. After every four or five lines leave a slightly wider gap so the lines flow in bundles, until the section is full.
  4. Optional: fill inFill every orb and pebble solid black, like wet stones in the current.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.