Ribspine
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Just inside the edge, draw a spine line that follows the edge all the way round, letting it wobble a little.
From the spine, draw thin wedges out to both sides, wide where they leave the spine and tapering to a point, all sweeping back the same way like the barbs of a feather. Fill them black, leaving slim white wedges between them.
Leave a narrow gap past the wedge tips, then draw the next spine inside, copying the first, and give it its own wedges. Keep stepping inward until the section is full.
Fitting it to the spaceLet the pattern take its cue from the nearest edge. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.