Doodlemoth

← All patterns

Ribbonrun

IntermediateCurvesGrowingEdge-huggingStrokes: line, curve, orb
Example of Ribbonrun
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redFrom the edge of the section, draw a flat ribbon, two lines a finger's width apart, that wanders inward in a long lazy S-curve. Let it swell a little toward the end and close it with a round tip.
  2. Step 2: the new strokes are redInside the ribbon, draw two or three lines that run its whole length beside its edges, swelling with it near the tip and stopping just short of the rounded end.
  3. Step 3: the new strokes are redAdd more ribbons from the edge, each with its inner lines, until the section is full. Each new ribbon passes behind the ones already there: stop its lines at the edge of the ribbon in front and carry on beyond it. Tuck a few tiny orbs into the crevices where ribbons meet.
  4. Optional: fill inFill the gaps between the ribbons solid black, leaving the little orbs white.

Next to another sectionWherever a line from the neighbouring section reaches the string line, let it widen into a ribbon that wanders on into this section.

Fitting it to the spaceLet the pattern take its cue from the nearest edge. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.