Rayfold
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Pick a point off to one side of the section. From it, draw long narrow kites out to the string line: each starts at the point, swells to its widest about a third of the way out and narrows to a sharp tip that touches the edge. Leave a gap between neighbours.
Between the long kites, add shorter ones that stop well short of the edge, so long and short take turns. Where a gap widens toward the edge, start a kite further out in it. If part of the section is out of reach, start a second, smaller burst there, its kites stopping at the ones already drawn.
Draw a fold line down the middle of every kite, from its base to its tip.
- Optional: fill inFill the half of every kite on the same side of its fold solid black.
Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.