Lasso
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Draw a little cluster: two orbs side by side, a short way apart, and one or two small orbs a little further out at the ends. Scatter clusters like this across the section, and tuck single small orbs into the gaps between them.
Loop a ribbon, two lines side by side, round the two bigger orbs of each cluster in a figure of eight, so it crosses itself between them. Start and end it behind a small orb. Wherever the ribbon reaches an orb, or the part of itself already drawn at the crossing, stop its lines and pick them up again on the far side, so it slips behind.
Wherever the ribbon slips behind an orb or behind itself, fill a short strip of it solid black, right up against the edge it tucks under, like a deep crevice.
Optional: fill inFill the background around the orbs and the ribbons solid black.
Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.