Ladderband
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Draw two long lines across the section close together, like a pair of rails. Leave a small gap and draw the next pair the same way, following the first, until the section is full of ribbons. Let every line run right to the edge of the section.
In each ribbon draw a sharp zigzag line that bounces from rail to rail all the way along, touching one rail, then the other, so the ribbon splits into a row of little triangular compartments, like leaning rungs.
Pick one rail of each ribbon. Fill every compartment that sits against it with close short lines, all leaning a little the same way, running from that rail to the bouncing line. Leave the compartments against the other rail white.
- Optional: fill inFill every compartment left white, against the other rail, solid black.
Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.