Knotwork
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Lightly pencil a few long looping paths that wander over the section and cross themselves and each other, with every crossing a clean X. Follow one path and, at its crossings, mark it over, under, over, under in turn; carry on along the other paths so every crossing has one path on top. Now, in pen, draw only the top piece at every crossing: two short parallel lines a little longer than the ribbon is wide.
Start joining: pick a path and run its two lines from one top piece to the next along the pencil path, keeping them an even distance apart. Where a line meets the edge of a ribbon on top, stop it there and pick it up again on the far side.
Carry on along every path in the same way, rounding the ribbons off smoothly where they turn back near the edge of the section, until every ribbon closes on itself with no loose ends.
- Optional: fill inFill every pocket between the ribbons solid black, so the knot stands out white.
Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.