Doodlemoth

← All patterns

Knotcord

IntermediateGridLinesStrokes: line, orb
Example of Knotcord
Drawn fresh in your browser each time.

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redStart with a band of knots. Draw a row of small upright ovals running alongside the nearest string line, with about two oval-widths between them, and draw two short bars across the waist of each one, like a knot tied round two cords. Under it draw a second row, each knot halfway between two above, then a third row lined up with the first.
  2. Step 2: the new strokes are redJoin the knots with cords. From the bottom of each knot draw two lines, one to the top of each of the two knots below it, so the cords zigzag into a diamond net. From the top of every knot in the first row, and from the bottom of every knot in the third row, draw two cords that spread a little apart and then hang straight away from the band, all evenly spaced.
  3. Step 3: the new strokes are redDraw more bands the same way until the section is full, leaving a stretch of hanging cords between one band and the next. Each knot in the first or third row of a new band gathers two neighbouring hanging cords already there, sitting right on their ends, and every cord stops where it reaches a knot. Knots and cords at the edge of the section simply run off it.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.