Doodlemoth

← All patterns

Hoopstack

IntermediateOrbsStrokes: orb, curve
Example of Hoopstack
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw a few rings, well apart across the section: each a slightly flattened orb with a smaller flattened orb inside it, set a little above its middle, like a donut seen from the side. Turn them different ways.
  2. Step 2: the new strokes are redFill the spaces with more rings tucked behind those, each a little smaller than the ones before. Draw each one until it meets a ring already there and stop, but where it passes behind a hole, carry its lines on inside the hole, since that part shows through. Let each ring overlap one or two others at most, and keep going until no gaps are left.
  3. Step 3: the new strokes are redOn every ring draw a curved line halfway across its band, round the lower side of the hole, stopping wherever the ring goes behind another one. Each ring now looks like a round tube.
  4. Optional: fill inFill the background between the rings and inside the holes solid black.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.