Heartcord
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Draw a heart lying on its side, its point aimed along the row. Behind it draw the next heart so that its point slips into the cleft of the first: start and stop its outline where it meets the first heart. Keep chaining hearts this way in a gently curving line right across the section, letting them vary a little in size, and every eight or so hearts draw one about twice as big, its cleft and point still on the line of the cord.
Draw the next cord beside the first, a small gap away and following its curve. Where it passes a big heart, let it bend gently out around it, keeping the same small gap, and then settle back; each cord after that follows the one before, so the bend grows softer as it spreads. Put a big heart into these cords now and then too, never right beside another big one, and keep adding cords until the section is full. Let the cords run right off the edge of the section.
Inside every heart draw an aura a little in from its outline, stopping it wherever the heart slips behind its neighbour. In each big heart draw a second, smaller aura inside the first.
- Optional: fill inFill the middle of every other small heart inside its aura, and the smallest heart in the very middle of every big one, solid black.
Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.