Doodlemoth

← All patterns

Gearwork

IntermediateOrbsStrokes: line, orb, dot
Example of Gearwork
Drawn fresh in your browser each time.
Fill in

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw a large cog: one closed line that goes round like an orb but steps out and back in again all the way round, making small square teeth, evenly spaced.
  2. Step 2: the new strokes are redInside the cog draw a smaller ring, and a solid black dot in the middle of it for the axle.
  3. Step 3: the new strokes are redDraw more cogs of different sizes around it, each tucked behind the ones already there: where its rim and teeth run into a cog already drawn, stop, and carry on where they come out the other side. Give each its ring and axle dot. Fill the small gaps with little cogs that are only teeth and a dot.
  4. Optional: fill inFill the background around the cogs solid black.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.