Echofoam
Fill in
You need a fine black pen, a pencil and a small square of paper.
Red shows what each step adds. Black is already on the paper.
Draw a fair-sized orb and go round it with two or three auras, close together and evenly spaced, like ripples.
Draw the next orb nearby with its own auras. When one of its auras runs into an aura already drawn, stop it there and pick it up again on the far side, so the rings crowd into one another. Keep adding orbs of different sizes until the section is packed.
In the small gaps left over, draw little orbs with a single aura, and put a dot in any gap too small for those.
- Optional: fill inFill the gaps left between the outer auras solid black.
Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.
Want to use it on a full tile? Get today's recipe.