Doodlemoth

← All patterns

Curlburst

BeginnerCurvesOrbsStrokes: curve, dot
Example of Curlburst
Drawn fresh in your browser each time.

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redScatter solid dots across the section, well apart from each other, leaving more room round some dots than others.
  2. Step 2: the new strokes are redAround each dot with plenty of room, draw a ring of curved arcs that all swing the same way, like a pinwheel. Start with a short arc, make each next one a little longer, and from halfway round make them shorter again, so the burst swells on one side and tapers back to where you started.
  3. Step 3: the new strokes are redGive the dots with less room smaller bursts of fewer, shorter arcs, made the same way. Put a few tiny dots in any gap still too small for a burst.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.