Doodlemoth

← All patterns

Brambleberry

IntermediateOrbsStrokes: orb, curve, line, dot
Example of Brambleberry
Drawn fresh in your browser each time.

You need a fine black pen, a pencil and a small square of paper.

Red shows what each step adds. Black is already on the paper.

  1. Step 1: the new strokes are redDraw a little cap of five pointed leaves with a short stalk. Below it, picture a plump berry shape, wide under the cap and narrowing to a rounded tip, and fill it with small orbs packed tightly together, every orb touching its neighbours. Draw the top orbs until they meet the cap leaves, and stop there; make the orbs near the edge of the berry a little smaller than the ones in the middle.
  2. Step 2: the new strokes are redAdd more berries all over the section, close together with only a small gap between them, some large and some small, pointing different ways. Give most of them a cap and stalk first, then pack the orbs up to the leaves in the same way. Make every berry big enough to hold at least eight orbs.
  3. Step 3: the new strokes are redWhere a space is too small for a berry, tuck in a single pointed leaf with a line down its middle, or one small orb on its own.
  4. Step 4: the new strokes are redInside every orb draw a tiny curved highlight near its top left edge. Then fill the little gaps between the orbs of each berry solid black, so the orbs glow.
  5. Step 5: the new strokes are redSprinkle tiny dots in the paper left between the berries and leaves.

Fitting it to the spaceLet rows and lines lean with the nearest edge instead of running dead straight. Don't rule or measure; eyeballed spacing looks better.

Want to use it on a full tile? Get today's recipe.